LED Picture Wave Art Frame

    You will need any LED strip, the one I am using is 12 mm wide aRGB with a density of 120 per meter, so if you want the effect shown, you need to go dense. I made the distance long enough so it will appear diffused enough for a 60 per meter LED strip      It houses 180x180mm pictures, shadow boxes or layered wave models. The two halves press fit together and uses common paperclips to retain the photo or whatever it is you want to display. Any issues, specific mounting option you need or questions, shoot a comment!       Assembly instructions:   Print the two models, the back plate needs to be printed white or transparent, it is up to you. I made a pause so it starts black and switches to white when it reaches the diffusion level.    Carefully remove the supports, there is a hole for hanging or you can just have it on the desktop (mount for a table stand on its way)     Cut a paper clip in half, and insert it into the holes. Use pliers to grab the paper clip but please be careful not to hurt yourself, always keep your fingers clear or wear protective gloves.     Voila, this simple device will retain your work of art (or mine!) for the whole world to marvel at!   There is a small groove for you to place the strip in. My strip had no adhesive sticker in the back, so I glued it with that useless Bosch glue pen.     I suggest you use magnets to keep that unruly strip firmly in place while you glue it or peel off the adhesive backing off it.        In the bottom there is a hole to pass the cables, might be a good idea to put a dab of silicone glue to prevent strain on the cable.       Simply slot it in the frontal part and you are done.