Thingiverse

Led Pole for ender 5

por Hrumque

1 Descargas

1 Likes

0 Makes

Led posts for corners, for Ender5 and similar.
In the base, the hole for the M4 screw, the thread is included in the model - but in order for it to screw in well, it should be threaded again after printing.

The height of the post is 60mm, which is enough for a piece of LED strip, COB LED, or a WS2812 strip or a tipical board with 8 WS LEDs, etc. At the bottom there are holes for the wires, and leds on all 4 poles - can be connected pararell (even 4 WS2812 strips - DI input pin connected together, they light efect will be identical)

It prints well when there are 4 posts on the table close to each other - there should be no problem with adhesion.

Fuente

Thingiverse

Lo que necesitas para imprimir: Intermedio Baja confianza

Pieza única Tornillería requerida

Soportes 1/3

Ensamblaje 0/3

Ajustes 1/3

Tamaño de cama 0/3

Postproceso 1/3

Impresora

FDM / FFF

Formato de archivo