Thingiverse
LED Remote Control Holder
von KDubPixelzapper
11
Downloads
6
Likes
0
Makes
Two 3D files are included. One is for a large remote, and also a small remote. Both files are saved in the orientation that they were printed with.
Both remotes have a larger slot cut in the front, that you can use your finger to slide the remote out of the holder. The larger-size remote has a notch cut on the side that you can use to "tap" the remote out of the holder.
The LED Remote Holders can be attached to surfaces using either double-stick tape or with #4 flat head wood screws. The holes in the back of the LED holder are counter-sunk for the #4 screws.
No supports were needed for printing.
Both remotes have a larger slot cut in the front, that you can use your finger to slide the remote out of the holder. The larger-size remote has a notch cut on the side that you can use to "tap" the remote out of the holder.
The LED Remote Holders can be attached to surfaces using either double-stick tape or with #4 flat head wood screws. The holes in the back of the LED holder are counter-sunk for the #4 screws.
No supports were needed for printing.
KDubPixelzapper veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
