Thingiverse
LED Ring Holder
door Natator
3
Downloads
2
Likes
0
Makes
This is a holder for an LED ring. Print the cover in a clear/opaque filament. Diffuses the light nicely.
The actual ring I had was made by Duinotech but I think it's a fairly standard size.
Outer ring diameter: 76 mm
Inner ring diameter: 54 mm
Note: Printed this the first time and fitted perfectly. Second time the fit was too tight. I then noticed that the circuit board wasn't a perfect circle, it had a couple of lumps where it hadn't been perfectly circular. Easy solution to this is to simply file off the lumps, takes a matter of seconds.
The actual ring I had was made by Duinotech but I think it's a fairly standard size.
Outer ring diameter: 76 mm
Inner ring diameter: 54 mm
Note: Printed this the first time and fitted perfectly. Second time the fit was too tight. I then noticed that the circuit board wasn't a perfect circle, it had a couple of lumps where it hadn't been perfectly circular. Easy solution to this is to simply file off the lumps, takes a matter of seconds.
Natator publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!