LED Snowflake

This is an LED snowflake ornament. The basic shape is based on https://www.thingiverse.com/thing:34850

Materials:
1 paperclip
Transparent PLA filament
1 CR2032 battery
1 3mm blue LED

How to Assemble:
1. Insert the LED into the hole with the rounded end facing towards the hole at the top of the snowflake. Make sure that the longer lead is facing to the left.
2. Insert the longer lead into the slot on the left and cut the end off so that it does not interfere with the cover.
3. Cut the end of the short lead and insert into the hole in the snowflake.
4. Insert the battery with the flat side facing outward (+).
5. Place the cover on the back (snaps in).

Insert a paperclip into the small hole on the back of the snowflake towards the top to pop off the cover and to remove the battery.

I used 0.2 layer height and 20% infill.