Thingiverse
LED spiral cone
von Scofferoff
16
Downloads
8
Likes
0
Makes
A spiral track cone to lay an LED strip around, 10mm track suitable for WS2812 strips. Approx 2M long.
150mm diameter, 75mm high, 50 degree slope, your printer might handle that without supports with a concentric pattern.
It would be nicer to have the track lay flat against the cone but the LED strips won't handle the compound curve.
Plenty of room inside to stuff any electronics.
Hang from the ceiling for fun times!
150mm diameter, 75mm high, 50 degree slope, your printer might handle that without supports with a concentric pattern.
It would be nicer to have the track lay flat against the cone but the LED strips won't handle the compound curve.
Plenty of room inside to stuff any electronics.
Hang from the ceiling for fun times!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
