Thingiverse
LED Spool Holder
1
Downloads
0
Likes
0
Makes
This is a printable LED Spool Holder that can hold up to 9 of the printable [LED Spool](https://www.thingiverse.com/thing:7012631). The pin screws into place so that it can be replaced in case it breaks or if it needs adjustments. Use the Blender file to change the size of the pin. **Supports required to print the pin. Make sure there is no support in the base plate thread (use a support blocker)**
The base is 210mm in diameter, the same as the [Large LED Spool](https://www.thingiverse.com/thing:7014106)
Designed by Sargon
The base is 210mm in diameter, the same as the [Large LED Spool](https://www.thingiverse.com/thing:7014106)
Designed by Sargon
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
