Thingiverse
LED Strip Clip
door AeroSteveO
1
Downloads
0
Likes
1
Makes
This is a small clip to hold an LED strip to the wall with a screw rather than the double stick tape that comes pre-installed on them. This should be printed vertically on the buildplate with support. This has a wider mouth and opening to allow for thicker LED strips. Do make sure to use screws that are lower profile than the one I used in the picture.
AeroSteveO publiceert ook op
56 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
