Thingiverse
LED Strip Clips
by PMishra
1
Downloads
3
Likes
0
Makes
I made these LED Strip Clips for my Ender 3D Printer Enclosure, these may not fit yours so make sure you do your research and take measurements before you print these. My enclosure support beams were ~8.24mm OD, the LED strip I used is 10mm Wide and 2.75mm thick.
These clips will 'clip' onto the support beams inside the enclosure and the square part with a bit of overhang will allow the LED to go in easily but not fall out. It's a snug fit
These clips will 'clip' onto the support beams inside the enclosure and the square part with a bit of overhang will allow the LED to go in easily but not fall out. It's a snug fit
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
