Thingiverse
LED Strip diffuser thinner top
von Triscus
81
Downloads
50
Likes
0
Makes
This is a remix of the [LED Strip mounting profile](https://www.thingiverse.com/thing:2533803) by [HansVaa](https://www.thingiverse.com/HansVaa).
The original top part has a thickness of approximately 1 mm. I changed this to 0.4 mm as it looks a bit better when printed with white PLA. Printing with 1mm made white light a bit yellow-ish
Further I made is a bit shorter (200mm) so I can print it without turning it on my plate
The original top part has a thickness of approximately 1 mm. I changed this to 0.4 mm as it looks a bit better when printed with white PLA. Printing with 1mm made white light a bit yellow-ish
Further I made is a bit shorter (200mm) so I can print it without turning it on my plate
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!