Thingiverse
Led Strip Flying Bear Ghost 5
von antoniolespaul
71
Downloads
70
Likes
0
Makes
The project is for a good LED strip lighting for the Flying Bear Ghost 5.
2 REAR media and 3 FRONT media must be printed.
To complete the work you need empty 10x10mm satin aluminum profiles (they can be purchased in hardware stores), on which the LED strips must be glued as desired but which are 10mm wide.
The connections must be made with two solder wires for the parallel connection and drilling the led profile as in the photo.
Below there is a hole to fit / glue 4 cylindrical neodymium magnets, diameter 6mm for a height of 5-6mm.
For those who use the chain, can avoid installing the rear aluminum profile.
The REAR holder has one of the windows for the output of the power cable.
For the project in the photo I used 12V 3000K SMD5050 LED strips.
2 REAR media and 3 FRONT media must be printed.
To complete the work you need empty 10x10mm satin aluminum profiles (they can be purchased in hardware stores), on which the LED strips must be glued as desired but which are 10mm wide.
The connections must be made with two solder wires for the parallel connection and drilling the led profile as in the photo.
Below there is a hole to fit / glue 4 cylindrical neodymium magnets, diameter 6mm for a height of 5-6mm.
For those who use the chain, can avoid installing the rear aluminum profile.
The REAR holder has one of the windows for the output of the power cable.
For the project in the photo I used 12V 3000K SMD5050 LED strips.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
