LED strip housing

This is housing for an LED light strip. I designed this with 2835 in mind, but i widened it to house basically any size LED strip. I put double-sided tape on the bottom and pop it up under a shelf. It focuses the light into a single direction. If you use white filament then it will reflect better, but i used black so the housing is less obvious on a black shelf. I hope you like it.

These are for sale on my store: https://www.etsy.com/listing/734763620/display-lighting-kit

INSTRUCTIONS
This requires some assembly. Usually, I print two v3-led-housing.stl, two v3-end-cap.stl, and one v3-adjoining-cap.stl. When they finish printing, you can slide the two pieces of housing into each end of the adjoining cap, and slide the end caps on each end. I run a strip of 2835 LEDs down the center (sometimes i double it up) and connect the strip to wiring which can be purchased on amazon. I've listed some pieces you can purchase on amazon to set it up the way I have. I bought dupont pin connecto