LED Strip Light Frame

I decided I wanted some Lighting on my printer and had a roll or them cheap 8mm 12v 6000k stick on strip lights that you cut to size. so i designed this frame in 4 parts with an over-locking section to glue the parts together together to make the whole frame.I have not made holes as i was not sure if I was going to stick it to the Anet A8 frame or screw it on. in the end i marked where i needed the holes while aligning it with the frame and screwed it to the frame then ran the led wire through the hole for the frame mounting and wired it up the the power supply, I designed this with shielding so the light does not produce any glare.