LED strip Mood Light

This is a simple LED strip diffuser lamp.

Screw the tower and base togheter, pull the led strip fully through the base and the small opening at the bottom of the tower and wind the strip around the tower (see images). The tower should fit LED strips around 4 metres. If all is used, screw the top cap on the tower to hide the top threads, If there is leftover strip, just put it over the top and into the base. Then put as much of the powercord you want to hide into the base and screw on the bottom. Finally screw on the outer shell.

Tip: If you use a transparent outer shell and have dot-LEDS (as I have and is visible in the images), the individual lights might show. If so, use non-transparent filament instead.

The base is ~7cm. high and 10cm wide, and the outer shell is ~24cm. for a total height of ~30cm.

Best of luck.