Thingiverse
LED Strip Mount for SuperRacer
door TownDrunk
22
Downloads
12
Likes
0
Makes
This is a mount I created for my FLSUN SuperRacer for a 100 mm long 24v LED strip. You can use an strip, up to 10 mm wide. I have a print-in-place hinged version (that swings out) and one that's solid. Except for the hinge, both versions are similar.
I mounted it to the frame with a single M3x10mm screw using T-nut M3 drop-in rotating V-Slot by DaVinci2000.
I ran the wire up the v-slot and added a switch to turn them off. I used these covers to hide the wiring: Extrusion V-Slot Covers by Crabiter.
I mounted it to the frame with a single M3x10mm screw using T-nut M3 drop-in rotating V-Slot by DaVinci2000.
I ran the wire up the v-slot and added a switch to turn them off. I used these covers to hide the wiring: Extrusion V-Slot Covers by Crabiter.
TownDrunk publiceert ook op
36 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!