Thingiverse
LED Strip Mount
door Stevengineer
112
Downloads
54
Likes
0
Makes
This is a simple holder I made for the common LED Strips. You can usually slide the strips in, but you can also lay one side in, then press the other side down into the channel too install them. it has a 45 degree surface on the back so you can put it flat, or in the corner on a 90 degree bend.
As is, it is 100mm long but scaling can adjust the length and how tight it fits.
As is, it is 100mm long but scaling can adjust the length and how tight it fits.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
