Thingiverse
LED Strip Offset Mount
von TheDocBennett
30
Downloads
19
Likes
0
Makes
A lot of my LED strip usage puts them right on the edge and you know the adhesive tape isn't keeping them put. All I changed from threeD_Designers model was I lopped off one of the "feet" so there would be a single screw hold. This allows a 5mm LED strip to be held in place at the edge of a doorframe, furniture or whatever.
Included are the single and multiple prints. I was able to print these "sideways" with no issue and no supports, just a 5mm skirt.
Included are the single and multiple prints. I was able to print these "sideways" with no issue and no supports, just a 5mm skirt.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
