LED Strip Roller Applicator

A simple tool for applying LED strip to surfaces by pressing it firmly down using a soft roller made of TPU. There are 2 wheel size options to choose from each with a tire made of TPU. The wheel is attached to the handle using a bolt/nut, dowel, or whatever is available that fits and is strong enough. There is a modifier mesh for area where the wheel attaches to make the forks stronger.

Includes a .3mf file setup for Bambu Studio and the Fusion 360 .f3d file.

LED Strip Install Instructions:
Remove the adhesive cover paper from the LED strip then place one end down on the cleaned surface. Line up the other end of the LED strip without letting the adhesive make contact with the surface. While holding the end up and in position, use this applicator to press the strip onto the surface using the roller. Press firmly , but not hard while rolling over the strip. Hold the loose end taught to prevent wrinkles which can damage the circuit traces and pads. For best adhesion power up the LED st