LED-Strip String Lamp

Materials Needed: 1. G-code and/or STL Files: Top and Bottom with Lid, For the LED clamp and transformer holder. (Only G-code files are available.) 2. Holes Specification: 6mm holes for the LED clamp, transformer holder, and STL files. 3. Steel Rods: Two rods, each 60cm in length. 4. Nuts and End Pieces: Four nuts for each plate and a total of four end pieces. 5. LED Strip: Length varies, ideally matching the length of your steel rods. In this example 2x 50cm 6. String: For winding around the lamp structure. 7. Transformer: Suitable for your country's voltage, outputting approximately 15 watts or as needed for your LED strip. Assembly Instructions: 1. Prepare the Clamps: Use the G-code files to create the LED clamps and transformer holder. 2. Inserting the LED Strip: Gently slide a knife or a thin tool into the back of the clamp to open it slightly. 3. Securing the LED Strip: Place the LED strip inside the clamp. 4. Closing the Clamp: Use the end piece (also provided in the G-code file