LED Tiki Torch

Edit 1/20/21: Cross hole in bottom added for hanging upside down under a tent or awning, or for a pin to fasten to the pole if desired.

I've shared the tinkercad design if anyone wants to modify: https://www.tinkercad.com/things/kVEv4icff9v-flame-mount

General:
PETG required, at least for the upper, as I saw the charge controller chip get to at least 170F during testing. Tolerance on printed parts accounts for a 0.40 nozzle. I printed with 0.30 layers bottom, 0.20 layers top, 4 perimiters and 15% infill using a 0.40 nozzle on a Prusa Mk3. Lower is Atomic Glow PETG (discontinued) and upper is Atomic CF PETG. I used supports for upper and lower, but especially the lower you might not need it if your briding is tuned well.

The flat portion on the lower section is for a name tag, or if you're fancy edit in an embossed name. For my use I see them left out in group camping areas, etc. and I wanted to make sure they come home.

Environmental Notes:
This is not water resistan