Thingiverse
LED torch holder
von LVK73_DK
0
Downloads
1
Likes
0
Makes
I made this bracket for my wife to hang her LED torches on our fence so i dont "kill" them when mowing the lawn.
i printed the prototype in orange PLA to see if they could survive in the sun. It works fine and i will print them in black.
The bracket is designed to be printed without support, using 8 lines of brim
i printed the prototype in orange PLA to see if they could survive in the sun. It works fine and i will print them in black.
The bracket is designed to be printed without support, using 8 lines of brim
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
