Thingiverse
lefty mud guard
von blatti71
2
Downloads
2
Likes
0
Makes
it might be useful to others as well. Feel free to alter or optimize it.
It did annoy me that I wasn't able to put a standard mud guard on the bike. See the dimensions of the standard mud guard I used on the picture.
The guard came with cable ties 5mmx1,2mm (see pictures of dimensions).
The lefty diameter is 40mm.
I used standard PLA. Layer thickness 0,32mm. Pop rivets diameter 4mm.The gap inside for the cable tie is 6x1,5mm. Outside as well. The Outside does hold the 0,9mm guard onto the lefty. I used small ties keep it in place.
Due to its suspension travel I placed it on the top.
It might be even possible to print the mud guard - it's your turn. I made my contribution.
It did annoy me that I wasn't able to put a standard mud guard on the bike. See the dimensions of the standard mud guard I used on the picture.
The guard came with cable ties 5mmx1,2mm (see pictures of dimensions).
The lefty diameter is 40mm.
I used standard PLA. Layer thickness 0,32mm. Pop rivets diameter 4mm.The gap inside for the cable tie is 6x1,5mm. Outside as well. The Outside does hold the 0,9mm guard onto the lefty. I used small ties keep it in place.
Due to its suspension travel I placed it on the top.
It might be even possible to print the mud guard - it's your turn. I made my contribution.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!