Thingiverse
Leg for Flsun Cube
por Artjom_b
6
Descargas
1
Likes
0
Makes
Leg for Flsun Cube
Was printed with PETG without any supports, but it is better to use them if You use PLA or ABS
The leg must be installed over original leg
It is better to put under the leg a piece of rubber or styrofoam to reduce the occilation of the printer
Was printed with PETG without any supports, but it is better to use them if You use PLA or ABS
The leg must be installed over original leg
It is better to put under the leg a piece of rubber or styrofoam to reduce the occilation of the printer
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
