Legion Go Wall Mount Dock

This is a wall mount for the Legion Go. I designed it for the A1 Mini technically it could go wider to accommodate the full size of the table portion of the Legion Go on the A1 but the mini worked perfectly to accommodate the thickest part of the tablet so do not think there would be a lot of value as the rest of the tablet portion tappers down. I did not print the TPU pads as I do not but TPU as this is my only practical use for it, I typically use the soft side of velcro tape to ensure the PLA is not rubbing against front or back of the tablet and provide a snug fit when docked, picture included of where I placed as well as amazon link to the velcro I use (I also use the velcro for my MacBook vertical docks). Glue the pads or place the soft side of the Velcro tape on each side of the screw holes as pictured.https://www.amazon.com/dp/B00006RSP1 DO NOT use the screw hole caps until after you have mounted the wall (they will be hard to get out), The screw hole caps can be printed in PLA