Lego 1x1 Circular

Made this to be printed in clear PLA and be used with the flashlight.

Depending on which end u want to face out (e.g. using it with the flashlight) print it upside down with supports.

I used concentric supports in cura so it prints only outer walls and roof, which is fast and works really well.


For large size print:

Use the two part version and you wont need any supports.
I made them so the main part has a small barrier indside that acts as a stop for the knob part.

I printed it with a single 0.6mm wall and concentric infill with 3mm between the infill lines.