Thingiverse
Lego Concorde Wall Mount
door campbellsoup__1
0
Downloads
0
Likes
0
Makes
I made this in about 10 minutes in Tinkercad for my LEGO Concorde
I haven't printed it yet personally.
the holes for the screws are 3.3mm in diameter.
The nub is 1.6mm on the sides and about 1.7mm heightwise.
It has about a 1-2 degree tilt on the nub so that the LEGO is less likely to fall.
Tell me any problems as i havent printed it yet, and ill fix it.
I haven't printed it yet personally.
the holes for the screws are 3.3mm in diameter.
The nub is 1.6mm on the sides and about 1.7mm heightwise.
It has about a 1-2 degree tilt on the nub so that the LEGO is less likely to fall.
Tell me any problems as i havent printed it yet, and ill fix it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
