LEGOs Technic Wall Mount

I wanted a LEG0 Technic car mount that was a bit more dynamic than the usual flat mounted to wall options that are readily available.This print includes:Wall mountPegs that can be moved around to fit specific carsTemplate to get multiple cars all mounted at the same angle for better aestheticsTime to print everything that you need is ~3hr and uses 143g of filament It's a little finicky to get setup but it's the best I could come up with in an afternoon and it worked so I didn't tweak it further. This is intended to work with the larger scale models like 1:10 - 1:8 and I have no clue how well it would work with smaller cars. The mount, which is about 6 inches, fits between the wheels of the larger cars and can sit flat on the bottom of the car. The pegs have a overhand on them that in big enough for a single 8mm brick to get hooked underneath and prevent the car from sliding off the slopped wall mount. I have only personally tested it on the Ferrari 488 and Porsche 911 RSR.