Thingiverse
Leitkegel
von ospalh
36
Downloads
30
Likes
0
Makes
Yet another traffic cone.
The point of this is that most of the weight is in the base, and the actual cone part is rather thin. Yu can tip this something like 70° and it will right itself. It’s basically impossible to blow this one over, at least on a flat surface.
The mesh is for a 50 mm high version. 1:10 scale for a standard European 50 cm (night-and-day non-autobahn) cone.
Designt for 0.4 mm nozzles.
The point of this is that most of the weight is in the base, and the actual cone part is rather thin. Yu can tip this something like 70° and it will right itself. It’s basically impossible to blow this one over, at least on a flat surface.
The mesh is for a 50 mm high version. 1:10 scale for a standard European 50 cm (night-and-day non-autobahn) cone.
Designt for 0.4 mm nozzles.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!