Thingiverse
Lelit Filterholder Stand (with weight)
door bob3dp
6
Downloads
3
Likes
0
Makes
This is a Filterholder stand for Lelit Filterholders (57mm). There is a weight (50mm diameter, 8mm height) added during printing. I used a lead disk, but steel etc. should work as well. The total weight is about 260g.
Note: If you do not add the weight the whole thing will probaply tip over.
Note: If you do not add the weight the whole thing will probaply tip over.
bob3dp publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
