MakerWorld
Hueforge & Lithophane
Ver Modelo
Leo
52
Descargas
36
Likes
16
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change the X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Gray Transmission Distance: 2PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filaments. Subtitute as needed. Swap Instructions:Start with BlackAt layer #10 (0.88mm) swap to Blue GrayAt layer #14 (1.2mm) swap to GrayAt layer #21 (1.76mm) swap to Jade White for the rest. Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp también publica en
338 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
