Thingiverse
Let's Split Keyboard Plate & Case
von mesohuannny
665
Downloads
551
Likes
4
Makes
This is a plate & case I built for a "Let's Split" keyboard. In the photos I used translucent filament.
PCB's will eventually be restocked here:
http://www.switchtop.com
I use these screws:
M3 x 0.5 mm Thread, 6 mm
https://www.mcmaster.com/#91292a111/=17q9c3e
PCB's will eventually be restocked here:
http://www.switchtop.com
I use these screws:
M3 x 0.5 mm Thread, 6 mm
https://www.mcmaster.com/#91292a111/=17q9c3e
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
