Thingiverse
Level 1 Rocket
von ryandgarrison
40
Downloads
17
Likes
0
Makes
These are parts I used on my Level 1 Certification rocket that flew on a Cesaroni H100 motor.
The nose cone is a 5:1 spherically blunted tangent ogive nose cone that fits a [T300-34](https://www.balsamachining.com/#) body tube. It prints in four pieces which can be glued together, sanded, and painted.
The tail cone doubles as a motor retainer and fits a [T38-34](https://www.balsamachining.com/#) 38 mm motor mount tube and has a notch modeled into it to allow for a rail lug to be placed at the bottom of the rocked body. There are two versions that work with a reloadable Cesaroni casing or a single use Aerotech.
The nose cone is a 5:1 spherically blunted tangent ogive nose cone that fits a [T300-34](https://www.balsamachining.com/#) body tube. It prints in four pieces which can be glued together, sanded, and painted.
The tail cone doubles as a motor retainer and fits a [T38-34](https://www.balsamachining.com/#) 38 mm motor mount tube and has a notch modeled into it to allow for a rail lug to be placed at the bottom of the rocked body. There are two versions that work with a reloadable Cesaroni casing or a single use Aerotech.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!