Leveled tamper (Customizable)

Simple and efficient design to get a leveled tamp all the time. First use WDT please.
You must customize the tamping cylinder so it fit your basket. You can do that by printing a test disk first. It will save you time and plastic. Make a puck as you would with your lower dosage minus 2g. Usually I dose a minimum of 14g so I will put 12g. Approximately mesure the diameter of the basket where it intersect the coffee. Change the innerbasketdiameter parameter and print a test disk. Put the test disk on the top of the coffee. If it does not enter or it get stuck, your diameter is to big, if it does not cover all the coffee, it is to small. Adjust innerbasketdiameter accordingly and print another disk. When your ok, print the two parts, cylinder first to test it. Watch out because when I printed it I experienced a little bit of warping when bridging the tamper guide.