Leveling and Test Print

This is a test print for bed leveling. You may have to run it multiple times for it to come out perfectly.

Note: This is designed for an Ender 3, so if you have a different printer I'm not sure if it'll work.

For bed leveling:
1. Grab a piece of normal copy paper.
2. Start the print.
3. Move the paper to the spot where the hot end is going
4. Move the paper back and fourth
5. Adjust the knobs so that you feel slight tension
6. Press RESUME PRINT
7. Repeat

For the Test Print:
1. Start the print
2. When the print finishes, look to see any flaws
3. If flaws, re-level and try again