Leveling File - FlashForge Creator Pro 2016

This is a bed leveling file for the Flashforge Creator Pro. It puts the left extruder DIRECTLY above the leveling screws as opposed to the stock leveling files that just put the extruder vaguely somewhere in the area. It also does away with a lot of the unnecessary instructions that just amounted to having to press the button a lot of extra times.

Instructions:
1. Don't download the SVG file, you just need the X3G.
2. Copy it to your FFCP2016's SD card
3. Put it in the FFCP2016.
4. Print From SD Card->Select BedLevel.x3g
5. Use the included leveling card to adjust each screw so that it slides through without any resistance, then back off even a small smidge from that.
6. The last point (where it says "Check Level") will probably make contact with the card. That's because the FFCP beds aren't really 100% flat. that's "OK" i guess... :-/
7. Do a test print, something small and let the first few layers print. If it sticks you're done! otherwise repeat steps 4-6 ever so slowly ti