Levitating Moon Lamp Base Remix

After making the original moon and base, I found the base didn't quite fit the magnet and coil properly, and it was so thin that the LEDs lit through it. Also, as the magnet is quite strong the heavier the base can be, the better. The LEDs are blue on the magnet, so the blue tone is achieved even with white PLA.

I printed this with Wood PLA and White PLA. I printed with .1mm layer height, and changed from wood to white at layer 246, and back to wood at layer 300. NO supports are needed for this print. The lid is made with the same Wood PLA, and will thread into the base.