Thingiverse
LG Fortune case
by Alobster111
10
Downloads
8
Likes
0
Makes
This a one piece case for the LG Fortune that is intended for stiffer filaments. It has two reliefs so one side will flex out to snap the phone in. With proper printing and care I was able to get my phone in and out with out breaking the case. I plan on uploading a version for flexible filaments.
It does make the phone a bit more clunky shaped but I wanted durability over sleek as these phones are very prone to break by flexing in a pocket (this happened to me). I dropped my phone on the corner from 5' in the air onto concrete and it survived in this case although it did make a small crack in the case.
The model may be at a 10% scale so make sure you scale it up in your slicer.
ALSO PRINT THIS 1% BIGGER WHEN USING ABS. I generally have around a 1% shrinkage with abs and if you do not do this the case will be very tight.
This phone has thermal throttling issues so I did a throttling test and the case only affected overall performance by 1% which was in the margin of error fo
It does make the phone a bit more clunky shaped but I wanted durability over sleek as these phones are very prone to break by flexing in a pocket (this happened to me). I dropped my phone on the corner from 5' in the air onto concrete and it survived in this case although it did make a small crack in the case.
The model may be at a 10% scale so make sure you scale it up in your slicer.
ALSO PRINT THIS 1% BIGGER WHEN USING ABS. I generally have around a 1% shrinkage with abs and if you do not do this the case will be very tight.
This phone has thermal throttling issues so I did a throttling test and the case only affected overall performance by 1% which was in the margin of error fo
Alobster111 also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!