LiamLucky13

Another variant of Liam to print. (https://www.facebook.com/groups/319588508137220/)

Neither wheels or clip disk are mounted using any special bolts but just uses m3 screws (and a nut for the drive wheels) to hold in place. Time will tell if it is good enough.

I used mostly 8mm M3 screws except for the drive wheel centers where the screw was a little longer.

The ClipDiskCage has hole from the top into the cage bars where a M2 screw can fit to provide extra strength.

Extra components outside the BOM (https://github.com/sm6yvr/liam/wiki/02.-BOM) are:

https://www.banggood.com/2pcs-NO-NC-Emergency-Stop-Switch-Push-Button-Mushroom-4-Screw-Terminals-p-1090219.html

https://www.kjell.com/se/produkter/el-verktyg/elektronik/elektromekanik/strombrytare/nivabrytare/tiltsensor-p36058

EDIT: Added version for 220mm max build length