Thingiverse
Lidl glider winglets for V2 version
por f2knpw
6
Descargas
7
Likes
1
Makes
two winglets for LIDL glider version2
They fit perfectly to the tips of the wings and do not prevent (pre cut) ailerons to move.
To get enough strength I printed them with 2 perimeters, 0% infill, 0 bottom layer and 0 top layers
Note that If you want lighter print then use a single perimeter (or spiral vase). This may need to scale down just a little the models.
Don't print them in PLA or they may not resist to sun in summer... Prefer PETG or PET.
They print vertically without supports
They fit perfectly to the tips of the wings and do not prevent (pre cut) ailerons to move.
To get enough strength I printed them with 2 perimeters, 0% infill, 0 bottom layer and 0 top layers
Note that If you want lighter print then use a single perimeter (or spiral vase). This may need to scale down just a little the models.
Don't print them in PLA or they may not resist to sun in summer... Prefer PETG or PET.
They print vertically without supports
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
