Thingiverse
Lift the bed fixed
von jason264235
0
Downloads
1
Likes
0
Makes
Mainly because the buttons on the bed board are broken
Want to design one to replace it!
I did it.
-----------------------------------------------------------
I use the following settings:
0.2mm layer height
Infill Density:100%
Generate Support: yes
Want to design one to replace it!
I did it.
-----------------------------------------------------------
I use the following settings:
0.2mm layer height
Infill Density:100%
Generate Support: yes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!