Thingiverse
Light house
por mikbund
16
Descargas
4
Likes
0
Makes
Transparent plastic for leds was printed in ABS, top and bottom was printed in PLA.
Two versions included. One with oled 0.96" display and dht22 sensor. The other one without.
Support is required if you print the case with oled display.
Note: Amica board is a bit smaller, therefor two versions
Two versions included. One with oled 0.96" display and dht22 sensor. The other one without.
Support is required if you print the case with oled display.
Note: Amica board is a bit smaller, therefor two versions
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
