Thingiverse
Light Ring Holder
door Greecher
21
Downloads
5
Likes
0
Makes
Requested a light ring holder by castabler for the Makita router using this light ring: https://www.amazon.com/dp/B078Y6MFNB/?coliid=I1Z1A1ZOZQ9VMI&colid=3DRNM378DIP60&psc=1&ref_=lv_ov_lig_dp_it.
This should print dead simple as is, no supports needed. I offset body by .2mm out, and place to hold ring by .2mm in. Left place for wire run opposite of clamp. Should only require a 5mm bolt/nut, and probably something like hot glue to fix the ring onto the holder.
This should print dead simple as is, no supports needed. I offset body by .2mm out, and place to hold ring by .2mm in. Left place for wire run opposite of clamp. Should only require a 5mm bolt/nut, and probably something like hot glue to fix the ring onto the holder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
