Thingiverse
light sensor housing
von Kdor
3
Downloads
0
Likes
0
Makes
It was to replace my Oregon UVN800 sensor which was defective.
Find the electronic part on github:
https://github.com/Cyril-44640/lux-meter-with-ATTINY85
Print in ABS
iIt will be necessary to paint the exterior in white for waterproofing.
and plug the hole with transparent silicone
glue the 2 inner parts and the 6 battery springs with acetone
For the contacts, I put points cut and welded with tin. But you can replace it with pieces of aluminum foil
Find the electronic part on github:
https://github.com/Cyril-44640/lux-meter-with-ATTINY85
Print in ABS
iIt will be necessary to paint the exterior in white for waterproofing.
and plug the hole with transparent silicone
glue the 2 inner parts and the 6 battery springs with acetone
For the contacts, I put points cut and welded with tin. But you can replace it with pieces of aluminum foil
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
