Thingiverse
Light-up Mario Star
by paenian
4
Downloads
5
Likes
0
Makes
Designed a Mario Star for my son's halloween costume. Modeled by our cat, Netty.
Uses this light: https://amzn.to/35PsEgk
and a short USB cable stuffed inside the hole on the back so you can easily recharge it.
I used hot glue to hold the lights around the perimeter, and then some red sparkly hot glue for the eyes. Switch is on the back - that light slots right in and is easily operable.
I printed in yellow transparent PETG; should work in nearly any plastic, though.
Uses this light: https://amzn.to/35PsEgk
and a short USB cable stuffed inside the hole on the back so you can easily recharge it.
I used hot glue to hold the lights around the perimeter, and then some red sparkly hot glue for the eyes. Switch is on the back - that light slots right in and is easily operable.
I printed in yellow transparent PETG; should work in nearly any plastic, though.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
