Light-up Rose with Stem (pluggable)

This is not really a remix. I just added a piece which makes assembly easier.

### Parts required

* some wire, red and black preferred
* some heat-shrink tubing
* red/blue/white LEDs, 14000mCd or more
* resistors, depending on the LEDs, I used 100Ohm for red, blue and white wouldn't even need resistors
* micro sliding switches (e.g. those: http://www.ebay.de/itm/S09-10-Stk-Mini-Schalter-Miniatur-Schiebeschalter-8-5x3-5x10-5-mm-/311585219557)
* CR2032 battery holders

### Circle shaped part

This piece of plastic needs to be glued to the bottom of the flower, with the protruding ring part facing down and -of course- the large round surface being super-glued to the base of the rose.

Test print it so that you find the right amount of fricton. The rose must stick firmly to the stem, but should be removable also, perhaps with a bit of twisting required.

This allows for a easier battery change in the future - no glue break ups required.

### Assembly

1. Well, print t