Light up scepter for giant nutcracker

This is a giant scepter for the 3-foot (150% profile) nutcracker model by mocodroid (https://makerworld.com/en/models/21948-ornamental-nutcracker-over-24-inches-tall?from=search#profileId-761277). The staff is designed to be threaded through a ½" wooden dowel. One of the tubes is closed, this is the bottom. There is a place to attach a 12x3mm round magnet at the bottom of this piece, press fit one in there, then go ahead and press fit the magnets into the lamp base and the globe (6x2mm). Thread the tubes over the dowel one by one, using a good helping of your favorite adhesive (e-6000 in my case). I found it was best to do this one at a time, letting each one dry for a few hours before putting the next on. You'll probably need to trim the dowel a bit, its fine if its under the last section, but you don't want any poking out above. Then put the lamp base on top of the top dowel with plenty of glue. Get another 12x3 magnet, stick it on to the one you put on the bottom of the