MakerWorld
Other House Models
Go to Model
Light weight knife holder
1.2k
Downloads
412
Likes
598
Makes
Despite of its dimension (247 x 118 x 135), it takes only 3h to print and weights less than 120g.It can hold up to 9 knives, 5 big models and 4 small ones, with a maximum of 220mm blade length.With this "opened" design vs a regular "block" model, it makes easier to spot the right size. Please make sure your print bed is clean enough to avoid warping :)Hope you will like it. V2 update on June 1st 2025:Based on some feedback, the “base” was extended 20mm to prevent it from toppling over, especially when the holder is fully loaded.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
