Lightbar 50mm

My first design to be uploaded.
*This may exist in some other capacity but none I found met this need.

I wanted an LED light that I could integrate into the printer.

This will fit into the standard extruded aluminum printer frame grooves.(20mm stock)

I created it in a 50mm length so that it could be printed in pieces to fit wherever and not have to be chopped down.

I ran them across the bottom of the top bar of my Ender 3 Pro and laced the wires through the crack on the right pillar past the screws. (I used cat 5 single wires for the +/-)

I used LED strip lighting from Amazon. The strip can be cut to length (16mm bits) and just soldered onto a USB cable and plugged into a source of your preference. I used USB power sticks while testing but eventually just plugged it into an unused USB port on my Raspberry pi.

The print settings of a default printer will print this just fine.
I printed the piece laying with the open groove down. It will put a sliver of a support insi