LightBlue 3D printer

In this instructable I will describe how to build your BlueLight 3D printer. It is the first 3D printer we produced and is the basic model. If you want, you can upgrade to DeepBlue 3D or even to DeepBlue 3D Pro.

Highlights: cube like frame, new cross XY rolling system design, servo Z probe for all bed surfaces, four point translation bed design, simple filament run out sensor, active cooling with laminar air curtain and Marlin 2.0 firmware (early stage).

The DeepBlue 3D Pro, the top of the Blue3D range has an active enclosure, wi-fi connection, raspberry pi with octoprint and direct extruder.
LightBlue 3D characteristics:

print volume 200x200x230 mm;
very rigid cube structure;
FDM technology;
minimum layer height of 0.06 mm;
heated bed & flexible PEI sheet bed;
autoleveling with servo probe;
e3Dv6 hotend type;
runout filament senzor M600;
top print speed 120 mm / sec;
Bowden or direct drive feed;
is open source;
has Marlin firmware with Z-axis synchronization.

T