Thingiverse
Lightbulb pull cord switch (+Source inventor)
von JelleWho
2
Downloads
0
Likes
0
Makes
Pre applied offset of 0,2mm
1. Print top+bottom
2. Add rope/wire through the top and make a knot
3. [optional] paint them
4. Glue both pieces together
1. Print top+bottom
2. Add rope/wire through the top and make a knot
3. [optional] paint them
4. Glue both pieces together
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!